D
Deleted member 35560
Guest
I am posting this, having looked to see if it had been posted before.
I decided to do a clean install of Tara on my wife's laptop and did as I normally do, set up the internet connection before starting to do. All went well and nothing to worry about until it reached the point of installing the Grub2 when it said there was a Grub2 failure and stopped.
I rebooted and checked the USB nothing wrong there. So I wondered if it was the ssd and put the spare one it and it came up with the same problem on that.
The solution I came up with was not to connect to the internet and proceeded with the install and it sailed past the Grub 2 and installed perfectly. When it had completed, after setting up the firewall I set up the internet connection and everything is fine.
I can't see any reports anywhere on this, so I wondered if anyone had come across it? If not and it happens to say this is how I resolved it
I decided to do a clean install of Tara on my wife's laptop and did as I normally do, set up the internet connection before starting to do. All went well and nothing to worry about until it reached the point of installing the Grub2 when it said there was a Grub2 failure and stopped.
I rebooted and checked the USB nothing wrong there. So I wondered if it was the ssd and put the spare one it and it came up with the same problem on that.
The solution I came up with was not to connect to the internet and proceeded with the install and it sailed past the Grub 2 and installed perfectly. When it had completed, after setting up the firewall I set up the internet connection and everything is fine.
I can't see any reports anywhere on this, so I wondered if anyone had come across it? If not and it happens to say this is how I resolved it