Search results

Hy, again me :) I think i found the Problem but i don't know how to solve. # ethtool sfp1 Settings for sfp1: Supported ports: [ TP MII FIBRE ] Supported link modes: 10baseT/Half 10baseT/Full 100baseT/Half 100baseT/Full...

Hy Thanks to answer me. The interfaces which have same mac address is in a distributed switch architecture ( no static mac address for them). eth2 (or sfp1 in my modified dts) has its own mac address. I've done some tests : Eth2 interface has two cages : rj45 and sfp. Only one can works at a...

Hy Here the output of the command lines you suggested to me. I must to apply static ip because of in dhcp, i doesn't take an ip. 192.168.9.2 is my gateway with 255.255.255.0 for mask # nano /gui/conf/interfaces_reseaux/sfp1 GNU nano 6.0 /gui/conf/interfaces_reseaux/sfp1 #manual...

Hy. I triée thé same configuration with two différent interfaces (eth0 ans eth2, not in same Time when i put a statix address ^^). Works with eth0, not with eth2. Iface eth0 inet dhcp Iface eth2 inet dhcp

Hy. First, Thank you to answer me. I used a Linux build from Buildroot. I tried with DHCP and ip static, respecting subnet mask (255.255.255.0) So i tried your test with two different kernels. First time based on a 5.10 version, found in the github of glodbalscale . The Interface, here is...

Hy Ladies and Gentlemen :) I worked on a Mochabin board from GlobalScale. I have a problem with my eth2 ( renamed sfp1 in my DTS). It cannot communicate with another devices. I can ifup the interface without error, but no flows. # ifup sfp1 [ 106.315811] mvpp2 f2000000.ethernet sfp1: PHY...

Hy. Resolved :) I just took another version of firmware.

Hy ^^ I am in France. Non Airport, Military or weather radar Next to me. I testes my wifi card in Another board(clearfog from Solidrun). It works. I tested my board with a wifi card which has a driver ath10k instead mt7915e. It works

Hy Thank you to answer me. Heer the output of the command you ask : # iw list | grep MHz Supported Channel Width: 160 MHz short GI (80 MHz) short GI (160/80+80 MHz) STBC Tx <= 80MHz...

Hy. I work on a board Mochabin from GloablScale. I tried to use a card mpcie ax with driver mt7915e. This board has two interfaces : 1 for 2.4gh and 1 for 5/6ghz. The 2.4 GHz works well. But i want to use thé 5/6ghz it blocks here : mgmt::deauth cb I tried the card on another board and it...