control+c signal is not working

Discussion in 'General Linux' started by maryyam, Sep 4, 2013.

  1. maryyam

    maryyam New Member

    Messages:
    3
    Likes Received:
    1
    Trophy Points:
    3
    I am using linux 2.6.32.13-Cavium-Octeon with MIPS architecture. On terminal when i press ctrl+c to terminate process; nothing happen. How can I trace this in my kernel to handle with it issue?
    'stty -a' output is:
    speed 115200 baud; rows 0; columns 0;
    intr = ^C; quit = ^\; erase = ^?; kill = ^U; eof = ^D; eol = <undef>;
    eol2 = <undef>; swtch = <undef>; start = ^Q; stop = ^S; susp = ^Z; rprnt = ^R;
    werase = ^W; lnext = ^V; flush = ^O; min = 1; time = 0;
    -parenb -parodd cs8 hupcl -cstopb cread clocal -crtscts
    -ignbrk -brkint -ignpar -parmrk -inpck -istrip -inlcr -igncr icrnl ixon ixoff
    -iuclc -ixany -imaxbel
    opost -olcuc -ocrnl onlcr -onocr -onlret -ofill -ofdel nl0 cr0 tab0 bs0 vt0 ff0
    isig icanon iexten echo echoe echok -echonl -noflsh -xcase -tostop -echoprt
    echoctl echoke
    Is there any issue with tty? Because when i "make menuconfig" there is no option for "enable tty"
    and command "bind -v" is also not working.


    Thanks
    Maryyam
  2. ryanvade

    ryanvade Administrator Staff Member Staff Writer

    Messages:
    1,260
    Likes Received:
    428
    Trophy Points:
    83
    Go to another TTY, use psgrep to get the PID of the proccess and then:
    Code:
    kill -9 PID
    Or install Htop, and use it to kill the process.

Share This Page